Good Morning All !
i am newbie of the forum so.. i hope this will be the right section for this topic. I recently bought a Canberra Series 10 MCA from Ebay (model 1003) which i have been testing in this hours... While the ADC part seems to work right.. i cannot say the same for the HV power supply which do not start !
I read the user manual and followed instruction so:
1) turn on "HV switch" on the back
2) set in the menu the HV voltage and enable it.
Unfortunately the HV status do not change and i always read on the display "HV OFF" .. no voltage appears on the HV connector.
Did i do something wrong? Dis somebody have the same problem ?
Does anybody have tecnical manual // Schematics (in particular the HV power supply) of this MCA?
Thanks in advance for collaborating,
Marco
CANBERRA SERIES 10 - HV PROVBLEM - SCHEMATICS WANTED
- Marco Tosini
- Posts: 8
- Joined: Fri Oct 21, 2016 3:17 am
- Real name: Marco
- Location: Milano - Italy
-
- Posts: 307
- Joined: Sat Aug 27, 2005 8:30 am
- Real name: rich normand
Re: CANBERRA SERIES 10 - HV PROVBLEM - SCHEMATICS WANTED
Send me a private message with an appropriate email that accepts attachments . I have a scan of the user and service manual (about 5 to 6 meg).
Also, if I remember correctly the bottom card has to be in the proper position for the software selected range if you have the dual polarity and selectable voltage option.
Also, if I remember correctly the bottom card has to be in the proper position for the software selected range if you have the dual polarity and selectable voltage option.
- Marco Tosini
- Posts: 8
- Joined: Fri Oct 21, 2016 3:17 am
- Real name: Marco
- Location: Milano - Italy
Re: CANBERRA SERIES 10 - HV PROVBLEM - SCHEMATICS WANTED
Dear Richard,
Thanks a lot for your support.unfortunetly I cannot send you private messages, they go in outgoig and seem to be blocked there. I will leave you my mail here :
tosini.marco@gmail.com
Thanks a lot, Marco
Thanks a lot for your support.unfortunetly I cannot send you private messages, they go in outgoig and seem to be blocked there. I will leave you my mail here :
tosini.marco@gmail.com
Thanks a lot, Marco
-
- Posts: 307
- Joined: Sat Aug 27, 2005 8:30 am
- Real name: rich normand
Re: CANBERRA SERIES 10 - HV PROVBLEM - SCHEMATICS WANTED
PM sent Marco.
Let me know if you get the info OK.
By the way I did get your last message via the fusor forum today.
Let me know if you get the info OK.
By the way I did get your last message via the fusor forum today.